Posts Tagged ‘toy’

Quick Ribbon Ring Teether Toy Tutorial

August 20, 2008

OK, I promised some of you I would get this wrote up, so here it is! 






Materials Needed:

  • 6 pieces of cotton woven fabric cut 2 x 3.5″
  • 3 pieces of fusible fleece interfacting cut 2 x 3.5″
  • 6 ribbons cut to 2.5 to 3 inches long
  • 2.5 to 3″ Unfinished wood ring
  • Iron
  • Sewing Machine

Step #1

Cut all pieces above. Iron Fusible Fleece to WRONG SIDE of 3 pieces of your cotton woven material.

Step #2

Sew 2 piece together RIGHT SIDES together using no more than a 1/4″ Seam allowance.  Start on the long side just 1/2″ from edge.  Be sure to go back and forth when you start to secure stitches.  Continue around and add a FOLDED piece of ribbon to each SHORT edge by folding and tucking it between the layers as shown in the picture.  I pinned them to stay in place but I actually tuck them in the ends as I sew along.   Stop sewing about 1/2″ from the edge on the long side you started on leaving a 1.5-2″ hole. 

Step #3

Trim the corners as shown and turn your pieces right side out through the hole you left on the long side.  Push corners out with a sharp object.  A pen or end of a pair of scissors works nicely.  Be sure not to poke through the fabric.   Turn the raw edges in along the hole you left.  Sew around the whole piece  1/8th” from edge.



Step # 5

I use a zipper foot and put my needle in the farthest left position.  Wrap your piece around the ring and match the edges.  Stitch along the edge of the wood ring as close as  you can.  Make sure to go back and forth to secure stitches when you start and finish.   Trim ends.  Repeat steps 2-5 for each piece!

Step #6

GIve to the baby of your choice and admire your work 😉




If you have any questions, just let me know!! 😀